Welcome The Flying Widget - Your Online source of Radio Controlled Hobby Parts
UBECS and voltage regulators
Home Online Store Trade Shows Used R/C Equipment News Support
A TURNIGY RECEIVER VOLTAGE PROTECTOR WHICH IS COMPATIBLE WITH ALL FUTABA,SPEKTRUM,HITEC,JR 2.4GHZ  RECEIVERS . PREVENTS RECEIVER BROWN OUT SYNDROME SPECIFICATION The Turnigy Voltage Protector helps prevent your receiver from dropping below its required operating voltage. This helps to eliminate "brown outs" and prevents your receiver from rebooting. It will also help reduced the load on your ESCs BEC and reduce the likelihood of glitching. Simply plug it in to any spare channel on your receiver. Operating Voltage : 3.2V - 11.1V (1s ~ 3s LiPo) Capacitor voltage: 16v Storage Capacity: 3300uf Weight: 6.1g  
 TURNIGY RECEIVER VOLTAGE PROTECTOR REDUCES 2.4GHZ RECEIVER  BROWN OUTS NEW IN BAG  £3.49 Each Posted   
Quantity :
6VOLT 3AMP UBEC 2-5S LIPOS ( 6-23 VOLTS ) THIS SMALL LIGHTWEIGHT UBEC FEATURES A HIGH EFFECIENCY SWITCH MODE DESIGN PROVIDING A BETTER HEAT DISSIPATION WHEN COMPARED TO LINEAR VOLTAGE REGULATERS.tHE SHIELDED PCB DESIGN AND OUT PUT EMF COIL HELPS PROVEIDE A STABLE AND LOW NOISE VOLTAGE OUTPUT. THIS UBEC ALSO FEATURES BUILT IN REVERSE POLARITY PROTECTION   SPECIFICATION INPUT 6VOLTS - 23 VOLTS ( 2S- 5S LIPOLY, LI-FE 2-6S AND 5-15S NIMH BATTERY PACKS OUTPUT 6VOLTS/3 AMPS ( LESS THAN 50MVPEAK TO PEAK VOLTAGE AT 2 AMP DIMENSIONS 23MM X 20MM X 7.7MM OVERALL WEIGHT 9.2 GRAMMES  
6VOLT 3AMP UBEC 2-5S LIPOS ( 6-23 VOLTS )   £5.75 Each Posted   
TURNIGY 3AMP UBEC WITH LOW VOLTAGE BUZZER A TURNIGY 3AMP UBEC WITH LOW VOLTAGE SAFETY BUZZER ALARM WHICH IS BRAND NEW IN THE BAG FOR USE WITH SPEEDCONTROLLERS REQUIRING A UBEC features a built in safety buzzer to warn you if your input power source drops below 6v. Features. Current: 3A (Max. 4A) Input voltage: 6v~23v (2S ~ 5S Lipo) Optional Output: 5.1V or 6.1V Weight: 13.6g (including wires)    
TURNIGY 3AMP UBEC WITH LOW VOLTAGE BUZZER   £5.45 Each Posted   
YKS UBEC 4 AMP FOR OPTO SPEED CONTROLLERS WITHOUT BEC A YKS 4AMP UBEC FOR OPTO SPEED CONTROLLERS WHICH IS BRAND NEW .FOR USE WITH SPEED CONTROLLERS REQUIRING A UBEC. Specification 1. Output Voltage: 5V@4A 2. Continuous output current: 4 Amps 3. Input: 5.5V-26V ( 2-6 cells lithium battery pack or 5-18 cells NiMH /NiCd battery)      
YKS UBEC 4 AMP FOR OPTO SPEED CONTROLLERS WITHOUT BEC   £5.49 Each Posted   
Quantity :
Quantity :
Quantity :